D-Link Router Default Password & IP Address
Find the default username, password, and IP address for D-Link Router. Access your D-Link Router admin panel with factory default credentials.
Default Credentials
2 Credentials| Username | Password | IP Address | Port | Protocol |
|---|---|---|---|---|
| admin | (no password) | 192.168.0.1 | 80 | HTTP |
| admin | admin | 192.168.0.1 | 80 | HTTP |
Port Forwarding Guide
Want to open ports for your D-Link Router? Set up servers, cameras, and games easily.
Factory Reset Guide
Forgot your password? Learn how to factory reset your D-Link Router to restore default credentials.
How to Login to D-Link Router
Follow these steps to access the D-Link Router admin panel using the default credentials listed above.
- Make sure your computer or phone is connected to the D-Link Router network via Wi-Fi or Ethernet cable.
- Open a web browser (Chrome, Firefox, Safari, Edge) and enter the device IP address into the address bar.
- When the login screen appears, type the default username and password from the table above.
- If the credentials work, you will be taken to the D-Link Router admin dashboard. If they fail, the password may have been changed — perform a factory reset.
- For security reasons, change the default password immediately after your first successful login.
Common Login Problems & Fixes
Cannot reach the login page
Confirm you are connected to the correct network and that the IP address is correct. Try a different browser or clear your browser cache.
Default password not accepted
Someone may have changed the password. Perform a factory reset to restore the original D-Link Router credentials.
Page loads but admin panel never opens
Check that you typed http:// (not https://) and that no VPN or proxy is intercepting traffic to the local IP.
Forgot the changed password
Hold the reset button on the D-Link Router for 10–15 seconds to restore factory defaults, then use the table above.
Security Tips for Router
Routers are the gateway to your home network. After logging into your D-Link Router, change the admin password, enable WPA3 (or WPA2-AES) Wi-Fi encryption, disable WPS, turn off remote management, and keep the firmware up to date.
About D-Link
D-Link is a manufacturer of network and IT hardware. Default credentials shipped with D-Link devices are publicly documented for setup and recovery purposes — that is why we maintain this database. After your first login you should always change the D-Link Router password to a strong, unique value.
Other D-Link Devices
Is Your Network Slow or Insecure?
Older modems and routers are vulnerable to cyberattacks and throttle your internet speed. Secure and accelerate your home network with a next-gen WiFi 6 Router from Amazon's bestsellers.
How to Reset D-Link Router
If the default credentials don't work, your device may have been configured with a custom password. To restore factory defaults:
- Locate the Reset button (usually a small pinhole on the back of the device)
- Press and hold the Reset button for 10-15 seconds using a paperclip
- Wait for the device to reboot (LEDs will flash)
- After the reset, use the default credentials from the table above to log in