iDirect first enable sshd telnet to router: Default Password & IP Address
Find the default username, password, and IP address for iDirect first enable sshd telnet to router:. Access your iDirect first enable sshd telnet to router: admin panel with factory default credentials.
Default Credentials
1 Credentials| Username | Password | IP Address | Port | Protocol |
|---|---|---|---|---|
| root | iDirect | - | 22 | SSH |
Port Forwarding Guide
Want to open ports for your iDirect first enable sshd telnet to router:? Set up servers, cameras, and games easily.
Factory Reset Guide
Forgot your password? Learn how to factory reset your iDirect first enable sshd telnet to router: to restore default credentials.
How to Login to iDirect first enable sshd telnet to router:
Follow these steps to access the iDirect first enable sshd telnet to router: admin panel using the default credentials listed above.
- Make sure your computer or phone is connected to the iDirect first enable sshd telnet to router: network via Wi-Fi or Ethernet cable.
- Open a web browser (Chrome, Firefox, Safari, Edge) and enter the device IP address into the address bar.
- When the login screen appears, type the default username and password from the table above.
- If the credentials work, you will be taken to the iDirect first enable sshd telnet to router: admin dashboard. If they fail, the password may have been changed — perform a factory reset.
- For security reasons, change the default password immediately after your first successful login.
Common Login Problems & Fixes
Cannot reach the login page
Confirm you are connected to the correct network and that the IP address is correct. Try a different browser or clear your browser cache.
Default password not accepted
Someone may have changed the password. Perform a factory reset to restore the original iDirect first enable sshd telnet to router: credentials.
Page loads but admin panel never opens
Check that you typed http:// (not https://) and that no VPN or proxy is intercepting traffic to the local IP.
Forgot the changed password
Hold the reset button on the iDirect first enable sshd telnet to router: for 10–15 seconds to restore factory defaults, then use the table above.
Security Tips for first enable sshd telnet to router:
Routers are the gateway to your home network. After logging into your iDirect first enable sshd telnet to router:, change the admin password, enable WPA3 (or WPA2-AES) Wi-Fi encryption, disable WPS, turn off remote management, and keep the firmware up to date.
About iDirect
iDirect is a manufacturer of network and IT hardware. Default credentials shipped with iDirect devices are publicly documented for setup and recovery purposes — that is why we maintain this database. After your first login you should always change the iDirect first enable sshd telnet to router: password to a strong, unique value.
Other iDirect Devices
View all iDirect devices and their default credentials.Is Your Network Slow or Insecure?
Older modems and routers are vulnerable to cyberattacks and throttle your internet speed. Secure and accelerate your home network with a next-gen WiFi 6 Router from Amazon's bestsellers.
How to Reset iDirect first enable sshd telnet to router:
If the default credentials don't work, your device may have been configured with a custom password. To restore factory defaults:
- Locate the Reset button (usually a small pinhole on the back of the device)
- Press and hold the Reset button for 10-15 seconds using a paperclip
- Wait for the device to reboot (LEDs will flash)
- After the reset, use the default credentials from the table above to log in